Click to view our Accessibility Statement or contact us with accessibility related questions at 855-740-8229.Skip to content
UP TO 40% OFF SITEWIDE. Shop Sale
Honeylove logo
Model in high-waist shapewear short
Shapewear fit help

Shapewear feels tight? Try this first.

It should feel firm. That’s the shaping.
Looking for help with a bra? Go to bra fit help
Looking for help with a top or bodysuit? Go to tops fit help
01 · Too tight overall

Shapewear feels tight? Try this first.

It should feel firm, but you should still breathe deeply and sit comfortably.
Side view of a model in a blush SuperPower Short
  1. Pull it all the way up.Bunched fabric makes it feel tighter.
  2. Wear it for an hour, tags on.The first few minutes feel the firmest.
  3. Do the sit test.Sit, bend and take a deep breath.
It fits when you can sit for an hour and breathe deeply.
Back to top
02 · Too loose

Get it sitting in the right place.

If you barely feel it, it may not be sitting in the right place.
Front view of a black SuperPower Short, hands at the waist
  1. Pull it all the way up.The shaping panels go over your midsection.
  2. Check the waistband.On high-waist styles, it goes up to your bra line.
  3. Look for wrinkles.Wrinkles mean extra fabric.
It fits when you feel a firm, even hold and the fabric is smooth.
Back to top
03 · Too long or short in the torso

Set the straps and gusset first.

Bodysuits fit by torso length as well as size.
Model in a sand Mid-Thigh Bodysuit
  1. Adjust the straps.Most length problems are strap settings.
  2. Set the gusset.Make sure it’s in place first.
  3. Line up the waist.The waist panel goes at your natural waist.
It fits when it’s smooth from shoulder to hip, with no bagging or pulling.
Back to top
04 · Hard to get on or off

Technique helps most.

Firm fabric doesn’t slide on like underwear. Technique helps most.
Back view of a model holding the waistband of a toffee SuperPower Short
  1. Step in one leg at a time.
  2. Fold the waistband over and pull up by the fold.No need to tug on the mesh.
  3. Roll it down to take it off.Don’t pull.
It fits when it goes on in a minute or two.
Back to top
05 · Boning pokes or shows

Boning should lie flat.

The boning should lie flat along your sides.
Side view of a black SuperPower Short along the side seam
  1. Straighten it.It runs straight up your side seam.
  2. Pull the waistband up.Boning bends when it sits too low.
  3. Check it after washing.Before you wear it again.
It fits when you can’t feel it when you sit.
Back to top
06 · Leg openings dig in

Pull the legs all the way up.

The legs may not be pulled all the way up, or the size is small.
Model lifting the leg opening of a black shaping short
  1. Pull the legs up.Hook your thumb through the gusset opening and lift the inner thigh.
  2. Smooth down your thigh.No bunching above the band.
  3. Sit for a few minutes.It grips most when you stand.
It fits when the leg band lies flat without a deep mark.
Back to top
07 · Bulge at the top edge

Raise the top edge.

The top edge is sitting too low or pressing in.
Side view of a black SuperPower Brief, top edge under the bust
  1. Raise the top edge.Pull it all the way up. On high-waist styles, that’s your bra line.
  2. Smooth it up your back.Make sure it isn’t folded over.
  3. Wear it where it’s designed to sit.Not lower.
It fits when the edge lies flat, with no line under your clothes.
Back to top
08 · Rolls down at the waist

Pull the waistband all the way up.

It’s not pulled all the way up, or the size is too small.
Close-up of the waistband of a sand SuperPower Brief
  1. Pull the waistband all the way up.On high-waist styles, that’s your bra line.
  2. Straighten the boning.Twisted boning lets the edge fold.
  3. Smooth from the bottom up.After you sit and stand.
It fits when it stays put when you sit, bend and walk.
Back to top
09 · How to put on your shapewear

Getting it on takes a little technique.

Keep the tags on until you’re sure.
Back view of a black SuperPower Short
  1. Step in one leg at a time.
  2. Fold the waistband over and pull up by the fold.It gives you a better grip. No need to tug on the mesh.
  3. Pull up the legs.If they drag, hook your thumb through the gusset opening and lift the inner thigh.
  4. Set the waistband.Pull it all the way up. On high-waist styles, that’s your bra line. The boning runs straight up your side.
  5. Smooth and sit.Smooth from the bottom up. Nothing should roll or bunch.
Back to top

Still not right? We’ll help.

Start an exchange, or talk it through with a fit specialist.
Start an exchange